Guides / Drinks

Swiss Water Decaf Coffee: How It Works and What to Expect

Swiss Water decaf coffee is coffee that has had its caffeine removed with water, time and carbon filters instead of chemical solvents. The beans are decaffeinated while still green, before roasting. This guide explains how the Swiss Water process works step by step, how much caffeine is left in the cup, and how it compares with the other ways to make decaf.

Swiss Water decaf at a glance

What removes the caffeine Water, with carbon (charcoal) filters; no chemical solvents
When On green, unroasted beans
How long About 8 to 10 hours for the whole process (the process owner's figure)
Caffeine removed The process owner says 99.9%; a science magazine puts the method at 94% to 96%
Caffeine left in a cup Very little: about 1 mg in the Mayo Clinic's chart, up to about 7 mg in another source
Flavor Most flavor is kept; no method removes only caffeine

How the Swiss Water process works

Popular Science describes four steps, and the process owner describes the same idea with a "green coffee extract":

  1. Soak. A batch of green beans is soaked in hot water. The water pulls out caffeine and other compounds.
  2. Repeat. The beans move to fresh water. Because that water has no caffeine, more caffeine leaves the beans. This repeats, up to 10 times, until almost no caffeine is left.
  3. Filter. The caffeine-rich water passes through activated charcoal filters. They trap caffeine and similar-sized compounds, while most other flavor compounds pass through.
  4. Reuse. The filtered water, now full of flavor compounds but almost free of caffeine, is used to soak the next batch of beans. Because it is already rich in flavor, the beans lose mainly caffeine.

The process owner says the whole cycle takes about 8 to 10 hours. Afterwards the beans are dried and shipped to be roasted.

How much caffeine is left?

Decaf is never fully caffeine-free. In the U.S., decaf is generally expected to have at least 97% of its caffeine removed, according to Healthline. The "99.9% caffeine-free" figure you see for Swiss Water decaf is the process owner's own figure for its decaf. A Popular Science write-up of the method gives a lower range of 94% to 96% for the process in general. The two figures come from different sources, so both are shown.

What matters in the cup is small either way. The Mayo Clinic's chart lists about 1 mg of caffeine in an 8 oz cup of brewed decaf, while Healthline says up to about 7 mg. For a full caffeine chart, see how much caffeine is in coffee.

Swiss Water vs other decaf methods

Method How it removes caffeine Chemicals?
Swiss Water Soaks and filters with water and charcoal None
Ethyl acetate A solvent that also occurs naturally in fruit Yes; the FDA considers it safe
Methylene chloride A solvent Yes; the FDA limits leftover residue to 10 parts per million
Carbon dioxide Liquid CO2 pulls out the caffeine No chemical solvent (liquid CO2 does the work); newer and more expensive, per Healthline

According to Popular Science, solvent methods remove slightly more caffeine (96% to 97%), and Swiss Water was commercially introduced in the early 1980s, while solvent methods date to the early 1900s. National Geographic notes the FDA limit of 10 parts per million for methylene chloride and says independent tests have found levels below it. In 2026 the FDA reopened public comments on a petition asking it to stop allowing methylene chloride in decaf; check for a final decision. A 2010 study National Geographic cites found Swiss Water and methylene chloride decaf had slightly lower antioxidant levels than ethyl acetate or CO2 decaf, though every method kept more than 80% of the original.

So the case for Swiss Water is mainly about how it is made, not about a safety problem with other decaf. If you prefer to avoid solvents on principle, the label is easy to find.

Does Swiss Water decaf taste different?

Yes, a little, and no decaf method keeps everything. Popular Science says no method can remove only caffeine, so some flavor compounds are always lost, and reusing the flavor-rich water gives back some but probably not all. A good decaf is a good coffee with a lighter kick, so the starting coffee and the roast matter as much as the method.

How to choose and brew a Swiss Water decaf

  • Start with a good coffee. Decaffeinating can't fix a poor bean. Look for a named origin, not just "decaf".
  • Check the roast date. Decaf goes stale like any coffee.
  • Brew it like normal coffee. About 15 g of coffee to 240 g of water; see our guide to brewing coffee.

Swiss Water decaf FAQ

What is Swiss Water decaf?

Coffee decaffeinated with water, time and carbon filters, with no chemical solvents.

Is Swiss Water decaf really chemical-free?

The process uses water, and charcoal filters to trap the caffeine, not chemical solvents.

Is Swiss Water decaf 100% caffeine-free?

No. The process owner's figure is 99.9% caffeine-free, and a cup still has a small amount, about 1 to 7 mg depending on the source.

How is Swiss Water decaf made?

Green beans are soaked in hot water, then in fresh water, repeatedly; the water passes through charcoal filters that trap caffeine and is reused to soak new beans.

Is Swiss Water decaf better than other decaf?

It avoids solvents. Other methods are also considered safe by the FDA, so the choice is partly about taste and preference.

Does Swiss Water decaf taste like regular coffee?

Close, but not identical. Some flavor compounds are lost in any decaf process.

From our shop

Want to taste it?

Night Rose is our Colombia Swiss Water decaf, from Pitalito, Huila, at 1,670 to 1,950 m. It is washed, decaffeinated with the Swiss Water process and medium roasted, with notes of milk chocolate, toasted hazelnut and dried fruit. Want the caffeinated version? Try Chocolate Orchard. Browse all our coffees.

Shop all coffees

More guides

All guides →